Optimization design and performance investigation on the cascaded packed-bed thermal energy storage system with spherical capsules

• Published in: Applied thermal engineering 2023-05, Vol.225, p.120241, Article 120241
• Main Authors: He, Xibo, Qiu, Jun, Wang, Wei, Hou, Yicheng, Ayyub, Mubashar, Shuai, Yong
• Format: Article
• Language: English
• Subjects: Experimental study; Numerical analysis; Optimized thermal performance; Optimized two-layered PTES system; Spherical PCM capsules
• ISSN: 1359-4311
• DOI: 10.1016/j.applthermaleng.2023.120241

•An optimized two-layered PTES system with high thermal performance was design.•Experimental analysis on the dynamic thermal-flow field was conducted.•The overall efficiency and the exergy efficiency of the OT-PTES system is higher.•The concentric diffusion model is used to further optimize the OT-PTES system. Most of the previous researches on the cascaded packed-bed latent heat storage (CPTES) system are the thermal performance optimization based on numerical calculation. Experimental studies are few and mainly focus on single design parameter at low-temperature conditions. Lack of the detailed temperature - flow field experimental data and optimization scheme for the CPTES system. In this paper, an optimized two-layered filling structure of packed-bed heat storage system (OT-PTES) was proposed, which considers melting temperature of phase change material (PCM), capsule diameter, and filling volume ratio. The heat transfer process of PCM capsule and heat transfer fluid (HTF) during charging/discharging process were studied in detail by experiments. Under consistent working conditions, the average charging/discharging rate, total heat capacity, overall efficiency, and exergy efficiency was evaluated. And the influences of HTF inlet flow and the volume filling ratio of two-layered on thermal performance were analyzed. Finally, the concentric diffusion model was used to simulate the system to further optimize its hierarchical structure. The results are concluded as follows: (1) The temperature difference between PCM capsule and HTF at the interface changes continuously, and there is also an obvious temperature gradient in the radial direction of HTF, which improves the heat transfer efficiency. (2) Through experiments, the packed-bed with single large/small size PCM capsules are compared with the OT-PTES system. The overall efficiency of the latter is 74.2%, increased by 3.38% and 8.28%, and the exergy efficiency is 62.7%, increased by 7.5% and 52%. It is proved that the OT-PTES system has better charging/discharging performance. (3) When the volume filling rate = 1/2, the system has the best thermal performance (75.04%) and exergy efficiency (67.1%). (4) The numerical simulation results show that the overall performance of the packed-bed is optimal when the capsule size composition is 20–30 mm and the temperature difference of PCMs melting point is 60 ℃. In summary, OT-PTES is an optimized system with better heat storage performance. This study can provide