Analysis and optimization of the heat transfer behavior in the melt-spinning process of Nd-Fe-B ribbons

• Published in: Applied thermal engineering 2024-07, Vol.248, p.123170, Article 123170
• Main Authors: Zhai, Haorui, Li, Xiaodong, Yu, Shuzhou, Lv, Ke, Hu, Yunzhong, Zhu, Wuwei, Huang, Qingfang, Fang, Yikun, Chang, Ying
• Format: Article
• Language: English
• Subjects: Heat transfer behavior; Melt-spinning process; Nd-Fe-B; NSGA-II MOGA; “Fluid-thermal” coupling
• ISSN: 1359-4311
• DOI: 10.1016/j.applthermaleng.2024.123170

•“Fluid-thermal” coupling simulation and FE-SEM observation reveals the heat transfer behavior in the MS process.•The relative error was within 5% by comparing the experimental and simulated outlet temperatures.•The finer and more even grains are formed on the roller-sticking surface of Nd-Fe-B ribbons due to rapid solidification.•Multi-nozzle heat source structure improves the average convective heat transfer coefficient and the utilization of the effective width of the roll surface.•NSGA-II MOGA was adopted for multi-objective optimization of process parameters. Heat transfer plays a significant role on the quality of Nd-Fe-B ribbons in the melt-spinning (MS) process. In this paper, the heat transfer behavior in the MS process of Nd-Fe-B ribbons was investigated by experiment and simulation. A full flow channel heat transfer model with high accuracy is established using the “fluid-thermal” coupling method. The temperature distribution of the cooling roller and fluid field in steady-state is obtained. The simulated and experimental results of the outlet temperature are compared and the relative error is within 5%. The microstructures of the free surface and roller-sticking surface of Nd-Fe-B melt-spun ribbons are characterized by FE-SEM, and the refined grains are formed on the roller-sticking surface of Nd-Fe-B ribbons due to rapid solidification caused by the heat transfer from the roller. Moreover, a multi-nozzle structure is proposed for the MS process. The temperature distribution on the surface of the cooling roller in the axial direction is more uniform compared with the original single-nozzle structure, and the average convective heat transfer coefficient is increased by about 1.27 times after the modification of multi-nozzle structure, with a productivity of three times. Finally, the experimental design method of Latin hypercube sampling response surface design is used to obtain the response surface relationships of rotational speed, inlet flow rate, and water inlet temperature on the surface temperature of the cooling roller, respectively. NSGA-II multi-objective genetic algorithm (MOGA) is adopted for multi-objective optimization of process parameters. The optimized combination of process parameters is obtained with a relative error of about 0.41%. The research results are helpful to understand the heat transfer behaviors in the MS process of Nd-Fe-B ribbons, improve the utilization rate of the cooling roller and enhance the production efficien