Biased scan of plasma display panel for data voltage reduction

• Published in: Displays 2012-01, Vol.33 (1), p.21-27
• Main Authors: Sung, C.H., Kim, J.H., Chung, Y.C., Jeon, M.J., Seo, J.W., Jung, Y.K., Kang, B.K.
• Format: Article
• Language: English
• Subjects: Applied sciences; Circuit properties; Data voltage reduction; Display; Electric, optical and optoelectronic circuits; Electrical engineering. Electrical power engineering; Electronic circuits; Electronic equipment and fabrication. Passive components, printed wiring boards, connectics; Electronics; Energy recovery circuit; Exact sciences and technology; Oscillators, resonators, synthetizers; Plasma display panel (PDP); Power electronics, power supplies; Scan method
• ISSN: 0141-9382; 1872-7387
• DOI: 10.1016/j.displa.2011.10.003

[Display omitted] ► The biased scan method uses two separate ground systems: FGND and CHGND. ► FGND and CHGND were connected for the reset period. ► A dc voltage bias was applied between FGND and CHGND for the address period. ► FGND and CHGND were disconnected for the sustain period. ► The voltage and power for the data drive circuit were reduced by 20V and 25W. This paper proposes a method of reducing the data voltage Vd of plasma display panels (PDPs). The proposed biased-scan method uses two separate ground systems: one for the sustain pulse generator (FGND) and the other for the data address and control systems (CHGND). A dc voltage bias, which is applied between CHGND and FGND during the address period, reduces Vd while preventing the undesired glow discharge induced by a scan pulse only. CHGND is connected to FGND for the first sustain pulse of each subfield, which reduces the time lag of address discharge, but it is separated from FGND for the other sustain pulses to increase the margin of the sustain voltage. The proposed method was tested on a 15% Xe 50-in. Full HD (1920×1080) single-scan PDP which had a sustain discharge gap of 110μm. Vd could be reduced by 20V (30%), and the power consumption of the Vd voltage source decreased by ∼25W (50%) from that of the conventional method.