Superplastic behaviors of a Mg–Zn–Y–Zr alloy processed by extrusion and equal channel angular extrusion

• Published in: Journal of alloys and compounds 2009-05, Vol.477 (1), p.636-643
• Main Authors: Tang, W.N., Chen, R.S., Han, E.H.
• Format: Article
• Language: English
• Subjects: Condensed matter: structure, mechanical and thermal properties; Cross-disciplinary physics: materials science; rheology; Deformation and plasticity (including yield, ductility, and superplasticity); ECAE; Exact sciences and technology; Extrusion; Inhomogeneous microstructure; Materials science; Mechanical and acoustical properties of condensed matter; Mechanical properties of solids; Mg–Zn–Y–Zr alloy; Other heat and thermomechanical treatments; Physics; Superplasticity; Treatment of materials and its effects on microstructure and properties
• ISSN: 0925-8388; 1873-4669
• DOI: 10.1016/j.jallcom.2008.10.089

Superplastic deformation (SPD) behaviors of a Mg–5.8%Zn–1.0%Y–0.48%Zr alloys produced by conventional extrusion and equal channel angular extrusion (ECAE) methods, respectively, have been comparatively studied in this paper. It is found that the optimum superplastic condition in as-extruded alloy was obtained at 450 °C and 3.3 × 10 −4 s −1 with the largest elongation to failure about 450%; while in as-ECAEed alloy it was at 350 °C and 1.7 × 10 −3 s −1 with about 800% elongation. Microstructural observations showed that structure evolution and cavity formation behaviors were different in these two materials during SPD. The probable mechanisms for superplasticity such as grain boundary sliding (GBS) and dynamic recrystallization (DRX) under different deformation conditions were discussed in terms of strain rate sensitivity, activation energy, as well as microstructural evolution.