Elucidating the deformation behavior of as-cast B2 CoTi intermetallic using in-situ tensile testing

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Structural materials : properties, microstructure and processing, 2023-04, Vol.871, p.144901, Article 144901
• Main Authors: Panda, Subha S., Sarvesha, R., Jain, Jayant, Singh, Sudhanshu S.
• Format: Article
• Language: English
• Subjects: Fracture; GNDs; Grain boundary; In-situ EBSD; Intermetallic; SSDs
• ISSN: 0921-5093; 1873-4936
• DOI: 10.1016/j.msea.2023.144901

This study deals with microstructural aspects of the deformation behavior of as-cast homogenized CoTi intermetallic by using in-situ tensile testing coupled with EBSD analysis. CoTi exhibits excellent wear resistance and noticeable room temperature ductility. Therefore, it is commonly used as coating material or a reinforcing phase in superalloys. In-situ study of this intermetallic is pertinent as it will provide information about the microstructural evolution during deformation under tensile loading. During the initial stage of deformation, the plastic strain localization was observed to occur at softer grains due to the activation of {011}⟨100⟩ slip systems, which resulted in the accumulation of GNDs and increase in fLAGBs (fraction of low angle grain boundaries). However, fLAGBs did not increase significantly at higher strains. In addition, the contribution of texture towards deformation behavior was found to be weak. The intermetallic exhibited a mixed-mode failure, where both transgranular and intergranular features were observed on the fracture surface. A slightly higher strain to failure in the intermetallic has been attributed to both the increase in the GNDs density at the initial stage of deformation and increase in SSDs at the later stage of deformation, leading to strain hardening.