Effect of Mg on elevated-temperature low cycle fatigue and thermo-mechanical fatigue behaviors of Al-Cu cast alloys

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Structural materials : properties, microstructure and processing, 2023-10, Vol.885, p.145588, Article 145588
• Main Authors: Hu, Peng, Liu, Kun, Pan, Lei, Chen, X.-Grant
• Format: Article
• Language: English
• Subjects: Al-Cu 224 cast alloys; Fatigue life prediction; Hysteresis energy model; Low cycle fatigue; Mg addition; Thermo-mechanical fatigue
• ISSN: 0921-5093; 1873-4936
• DOI: 10.1016/j.msea.2023.145588

The effects of Mg addition on the cyclic deformation and fatigue life behaviors of Al-Cu 224 cast alloys were investigated under isothermal low cycle fatigue (LCF) at 300 °C and out-of-phase thermo-mechanical fatigue (OP-TMF) in the temperature range 60–300 °C. The results show that all tested alloys experienced cyclic softening during both LCF and OP-TMF, whereas the softening ratio of Mg-containing alloys was lower than that of the base alloy free of Mg because of the lower coarsening rate of θ'-Al2Cu precipitates. Under both LCF and TMF, near-surface porosity and brittle intermetallic particles were considered sources of crack initiation. TMF lives were inferior to LCF lives under the same strain amplitude because of the combined damage effect of the cyclic mechanical and thermal loadings. Under LCF, the addition of Mg enhanced the fatigue performance because of the co-existing θʹ and θʺ precipitates and the higher thermal resistance of θʹ; under TMF, it led to a slight reduction in fatigue performance. The hysteresis energy model was successfully applied to predict the LCF and TMF lifetimes. The predicted results agree well with the experimentally measured LCF and TMF lifetimes.