Excellent combination of strength and ductility in austenitic lightweight steel achieved by warm rolling process

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Structural materials : properties, microstructure and processing, 2024-10, Vol.913, p.147066, Article 147066
• Main Authors: Li, Yuanzhang, Chen, Xingpin, An, Yanfei, Xie, Jing, Zhang, Xiaoyu, Cao, Wenquan
• Format: Article
• Language: English
• Subjects: B2 intermetallic; Lightweight steel; Ultra-fine grains; Ultra-high strength; Warm rolling
• ISSN: 0921-5093
• DOI: 10.1016/j.msea.2024.147066

In this study, warm rolling was applied to Fe–28Mn–11Al–1C–5Ni (wt.%) austenitic lightweight steel, which realized the higher dislocation density and finer dislocation-cell structures, achieving a better mechanical properties with ∼2.0 GPa of yield strength and ∼6.8 % of total elongation than cold rolling in the same conditions. In the subsequent partial recrystallization condition, the numerous dislocations and substructures existed in warm rolled steel provide more heterogeneous nucleation sites for grain refinement, resulting in the ultrafine-sized austenite and B2 with the size of 0.36 μm and 0.24 μm, respectively. Combined with grain refinement strengthening, solid solution strengthening, precipitation strengthening, and dislocation strengthening in the unrecrystallized austenite, the present steel shows an ultimate tensile strength of 1734 MPa, a uniform elongation of 21.7 % and a specific tensile strength of 267 MPa g−1 cm3. Such an excellent combination of strength and ductility induced by simple warm rolling and annealing is much better than previously reported for lightweight steels.