Wear-reducing Surface Functionalization of Implant Materials Using Ultrashort Laser Pulses

• Published in: Physics procedia 2015, Vol.78, p.320-327
• Main Authors: Oldorf, P., Peters, R., Reichel, S., Schulz, A.-P., Wendlandt, R.
• Format: Article
• Language: English
• Subjects: mirco-structuring; surface functionalization; ultrashort laser pulses; wear reducing
• ISSN: 1875-3892; 1875-3892
• DOI: 10.1016/j.phpro.2015.11.046

The aim of the project called “EndoLas” is the development of a reproducible and reliable method for a functionalization of articulating surfaces on hip joint endoprostheses due to a reduction of abrasion and wear by the generation of micro structures using ultrashort laser pulses. On the one hand, the microstructures shall ensure the capture of abraded particles, which cause third-body wear and thereby increase aseptic loosening. On the other hand, the structures shall improve or maintain the tribologically important lubricating film. Thereby, the cavities serve as a reservoir for the body's own synovial fluid. The dry friction, which promotes abrasion and is a part of the mixed friction in the joint, shall therefore be reduced. In experimental setups it was shown, that the abrasive wear can be reduced significantly due to micro-structuring the articulating implant surfaces. To shape the fine and deterministic cavities on the surfaces, an ultra-short pulsed laser, which is integrated in a high-precision, 5-axes micro-machining system, was used. The laser system, based on an Yb:YAG thin-disk regenerative amplifier, has an average output power of 50W at the fundamental wavelength of 1030nm, a maximum repetition rate of 400kHz and a pulse duration of 6 ps. Due to this, a maximum pulse energy of 125μJ is achievable. Furthermore external second and third harmonic generation enables the usage of wavelengths in the green and violet spectral range.