Design of high voltage capacitor charger with improved efficiency, power density and reliability

• Published in: IEEE transactions on dielectrics and electrical insulation 2013-08, Vol.20 (4), p.1076-1084
• Main Authors: Ryoo, H. J., Jang, S. R., Jin, Y. S., Kim, J. S., Kim, Y. B., Ahn, S. H., Gong, J. W., Lee, B. H., Kim, D. H.
• Format: Article
• Language: English
• Subjects: Capacitors; Density measurement; HVDC converters; Power system measurements; pulsed power systems; Reliability; Resonant frequency; resonant power conversion; Snubbers; Switches
• ISSN: 1070-9878; 1558-4135
• DOI: 10.1109/TDEI.2013.6571420

This paper describes the design of a 48 kJ/s high-voltage capacitor charging power supply (CCPS), focusing on its efficiency, power density, and reliability. On the basis of a series-parallel resonant converter (SPRC) that provides high efficiency and high power density owing to its soft-switching, the design of the CCPS is explained in detail, including its input filter, resonant tank parameters, high-voltage transformer and rectifier, as well as its protection circuit. By using two resonances per switching cycle, which provides a trapezoidal instead of a sinusoidal waveform of the resonant current, the proposed CCPS can take advantage of the lower conduction loss and reduced switching loss by improving the crest factor and allowing a higher value of the snubber capacitor, respectively. In addition, the compact design of an input filter without bulky components such as a DC reactor and an electrolytic capacitor allows for high power density, a high power factor, and low cost. In addition, the control loops for the voltage and current were optimized with a fast response time in order to compensate for the low frequency ripple of the input voltage, which results from the reduced filter component. Experiments on the developed charger were carried out with both resistor and capacitor loads in order to measure not only its efficiency and power factor with respect to the output power but also its charging time, in order to estimate the average charging current. The experimental results obtained with a resistor load showed a maximum efficiency of 96% and a power factor of 0.96 for a full-load condition. For the measured charging time of a 4 mF capacitor, with 9.68 s for 10 kV charging, the average charging current was estimated as 4.13 A. Moreover, to verify the reliability of the developed CCPS, a variety of tests, including opening and shorting of the output terminal as well as misfiring of the discharge switch during the charging operation, were performed with a 200 kJ pulsed power system. Finally, it was experimentally confirmed that the developed CCPS shows high performance in terms of efficiency (96 %), power factor (0.96), and reliability with a high power density (820 W/L).