Effect of build direction on the fracture toughness and fatigue crack growth in selective laser melted Ti-6Al-4 V

• Published in: Fatigue & fracture of engineering materials & structures 2015-10, Vol.38 (10), p.1228-1236
• Main Authors: Edwards, P., Ramulu, M.
• Format: Article
• Language: English
• Subjects: additive manufacturing; fatigue crack growth; fracture toughness; selective laser melting; selective laser sintering; titanium
• ISSN: 8756-758X; 1460-2695
• DOI: 10.1111/ffe.12303

Experimental investigation was conducted to evaluate the fracture toughness and fatigue crack growth characteristics in selective laser‐melted titanium 6Al‐4 V materials as a follow‐on to a previous study on high cycle fatigue. For both the fracture toughness and crack growth evaluation, the compact tension specimen geometry was used. It was found that the fracture toughness was lower than what would be expected from wrought or cast product forms in the same alloy. This was attributed to the rapidly cooled, martensitic microstructure, developed in the parts. At low stress ratios, the crack growth rates were faster than in wrought titanium but became comparable at higher ratios. The fracture toughness appears to be higher when the crack is oriented perpendicular to the build layers. The difference in the average threshold and critical stress intensity values for the crack growth results for the three orientations was within the scatter of the data, so there was essentially no difference. The same was true for the empirically derived Paris Law constants. Residual stresses were likely to have overshadowed any variation in crack growth because of microstructural directionalities associated with build orientation.