CAA-based optimisation of a sensor array to characterize aft and forward fan noise in a 3D nacelle

• Published in: The Journal of the Acoustical Society of America 2012-04, Vol.131 (4_Supplement), p.3468-3468
• Main Authors: Mincu, D.-C., Manoha, E., Polacsek, C.
• Format: Article
• Language: English
• ISSN: 0001-4966; 1520-8524
• DOI: 10.1121/1.4709077

In the context of the on-going European project JTI-SFWA, the modal acoustic content inside a realistic fan duct, designed by Dassault-Aviation, must be characterized experimentally. The objective is to use Onera's CAA solver sAbrinA-V0 to design a non-intrusive sensor distribution inside the nacelle, upstream/downstream the fan plane, accounting for the heterogeneous mean flow and the complex internal geometry. By computing the propagation of several interacting modes in the duct, a region in which the acoustic pattern is close to the infinite duct analytical solution was characterized. Then several 3D distributions of pressure sensors were tested in this zone. Radial and azimuthal sensor arrays were located at the nacelle wall, whereas a radial sensor array was placed along the bifurcation leading edge, without additional intrusivity. The response of the 3D arrays to a given acoustic field, either analytical or propagated through CAA, was projected on an analytical modal basis. For several array configurations, this projection clearly showed the emergence of the modal injected content. From these simulations, the most efficient sensor distribution will be used to equip an experimental fan noise simulator, and the modal projection process will be applied on measurements to evaluate the actual modal content in the duct.