Influence of Photoinitiator System on Physical-Chemical Properties of Experimental Self-Adhesive Composites

• Published in: Brazilian dental journal 2017-02, Vol.28 (1), p.35-39
• Main Authors: Bertolo, Marcus Vinicius Loureiro, Moraes, Rita de Cássia Martins, Pfeifer, Carmem, Salgado, Vinícius Esteves, Correr, Ana Rosa Costa, Schneider, Luis Felipe J.
• Format: Article
• Language: English
• ISSN: 0103-6440; 0103-6440
• DOI: 10.1590/0103-6440201700841

Abstract The aim of this study was to determine the influence of photoinitiator systems on physical-chemical properties of flowable composites. Conventional (CFC), composed by bisphenol-glycidyl dimethacrylate (BisGMA)+triethyleneglycol dimethacrylate (TEGDMA), and self-adhesive (SAFC), composed by BisGMA+TEDGMA+bis{2-(methacryloyloxy) ethyl} phosphate (2MP), flowable composites were developed. Five photoinitiator systems were tested: camphorquinone (CQ), ethyl-4-dimethylaminobenzoate (EDMAB), diphenyl(2,4,6-trimethylbenzoyl)phosphine oxide (TPO), phenylbis (2,4,6-trimethylbenzoyl)phosphine oxide (BAPO), CQ+EDMAB+TPO and CQ+EDMAB+BAPO. A two-peak LED was used; degree of conversion (DC) and the maximum polymerization rate (RPmax) were determined by near infrared spectroscopy. For the yellowing degree a spectrophotometer was used. Water sorption (Wsp) was obtained after 30 days of water storage (n=5). Data were submitted to two-way analysis of variance and Tukey’s test (a=0.05). BAPO presented the highest DC and RPmax values for both series. SAFCs presented lower DC and RPmax for CQ+EDMAB-based materials. Greater yellowing was observed for SAFCs compared with CFCs, except for BAPO. Greater Wsp was observed for SAFCs compared with CFCs. The photoinitiator did not influence Wsp for CFCs, but TPO and BAPO presented the highest Wsp in SAFCs. The photoinitiator system affected differently the physical-chemical properties of CFCs and SAFCs. Resumo O objetivo do estudo foi determinar a influência do sistema fotoiniciador sobre as propriedades físico-químicas de compósitos fluidos. Os compósitos convencionais foram compostos por bisfenol-glicidil dimetacrilato (BisGMA) + trietilenoglicol dimetacrilato (TEGDMA), e os autoadesivos, apresentavam BisGMA +TEGDMA+ Bis2(metacriloiloxi)etil fosfato (2 MP). Cinco sistemas fotoiniciadores foram testados: canforquinona + etil-4- dimetilamino benzoato (CQ+EDMAB), óxido mono-alquil fosfínico (TPO) e óxido bis-alquil fosfínico (BAPO), CQ+EDMAB+TPO e CQ+EDMAB+BAPO. LED de amplo espectro foi usado; o grau de conversão (GC) e a taxa de polimerização (TP) foram determinados por espectroscopia próximo ao infravermelho; o grau de amarelo foi mensurado por um espectrofotômetro e absorção de água foi obtida após 30 dias de armazenamento em água (n=5). Os dados foram submetidos a análise de variância de dois fatores e teste de Tukey (?=0,05). BAPO apresentou os maiores valores de GC e TP nos compósitos convencionais e autoadesivos. Compós