Coatings of indium tin oxide nanoparticles on various flexible polymer substrates: Influence of surface topography and oscillatory bending on electrical properties

• Published in: Journal of the Society for Information Display 2008-04, Vol.16 (4), p.559-568
• Main Authors: Königer, Tobias, Münstedt, Helmut
• Format: Article
• Language: English
• Subjects: bending; flexible polymer substrates; Indium tin oxide (ITO); ITO nanoparticles; oscillatory testing; printable electronics
• ISSN: 1071-0922; 1938-3657
• DOI: 10.1889/1.2905043

— Coatings of indium tin oxide (ITO) nanoparticles on different flexible polymer substrates were investigated with respect to the achievable sheet resistance and their electrical behavior under oscillatory bending. As substrate materials, polyethyleneterephthalate (PET), polyethylenenaphthalate (PEN), polyetheretherketone (PEEK), and polyimide (PI) were chosen, the surface resistances on the different polymer substrates were compared as a function of annealing temperature and surface topography. The surface topography, which has a strong influence on the surface resistance, was characterized by means of a white‐light confocal (WL‐CF) microscope. On the PET substrate, which exhibits the smoothest surface, the coating of ITO nanoparticles shows the lowest sheet resistance of 2 kΩ/□ for a layer thickness of 3 μm and an annealing temperature of 200°C. Furthermore, the electrical behavior of coatings of ITO nanoparticles under oscillatory bending was investigated using a special device. These coatings show a cyclic change of the conductivity which can be explained by an alternating compression and extension of crack flanks under the applied stress. Due to the growing number of cracks with increasing number of cycles, a decrease of the conductivity is observed in the bent state as well as in the balanced state. For a small bending radii, the decrease of the conductivity is stronger due to more cracks caused by the higher tensile stresses in the layer. The electrical behavior of the coatings of the annealed ITO nanoparticles on PET films under oscillatory bending was compared with commercially available sputtered ITO coatings. The annealed coatings of ITO nanoparticles demonstrate better electrical properties under oscillatory bending than coatings of sputtered ITO. The different electrical behavior under oscillatory bending can be related to differences in crack formation.