Strain Hardening, Damage and Fracture Behavior of Al-Added High Mn TWIP Steels

• Published in: Metals (Basel ) 2019-03, Vol.9 (3), p.367
• Main Authors: Madivala, Manjunatha, Schwedt, Alexander, Prahl, Ulrich, Bleck, Wolfgang
• Format: Article
• Language: English
• Subjects: Aluminum; Automotive materials; Automotive parts; Crack initiation; Crack propagation; damage; Damage assessment; Deformation analysis; Deformation effects; Deformation mechanisms; deformation twinning; Ductility; Dynamic strain aging; Edge dislocations; fracture; Grain boundaries; Grain size; Hot rolling; Inclusions; Interception; Manganese; Mechanical properties; Microcracks; Necking; Nucleation; Precipitation hardening; Propagation; Room temperature; serrated flow; Shear tests; Stacking fault energy; Strain hardening; Stress concentration; Temperature; Tensile properties; Titanium alloys; TWIP steel; TWIP steels
• ISSN: 2075-4701; 2075-4701
• DOI: 10.3390/met9030367

The strain hardening and damage behavior of Al-added twinning induced plasticity (TWIP) steels were investigated. The study was focused on comparing two different alloying concepts by varying C and Mn contents with stacking fault energy (SFE) values of 24 mJ/m 2 and 29 mJ/m 2 . The evolution of microstructure, deformation mechanisms and micro-cracks development with increasing deformation was analyzed. Al-addition has led to the decrease of C diffusivity and reduction in tendency for Mn-C short-range ordering resulting in the suppression of serrated flow caused due to dynamic strain aging (DSA) in an alloy with 0.3 wt.% C at room temperature and quasi-static testing, while DSA was delayed in an alloy with 0.6 wt.% C. However, an alloy with 0.6 wt.% C showing DSA effect exhibited enhanced strain hardening and ductility compared to an alloy with 0.3 wt.% C without DSA effect. Twinning was identified as the most predominant deformation mode in both the alloys, which occurred along with dislocation glide. Al-addition has increased SFE thereby delaying the nucleation of deformation twins and prolonged saturation of twinning, which resulted in micro-cracks initiation only just prior to necking or failure. The increased stress concentration caused by the interception of deformation twins or slip bands at grain boundaries (GB) has led to the development of micro-cracks mainly at GB and triple junctions. Deformation twins and slip bands played a vital role in assisting inter-granular crack initiation and propagation. Micro-cracks that developed at manganese sulfide and aluminum nitride inclusions showed no tendency for growth even after large deformation indicating the minimal detrimental effect on the tensile properties.