Experimental Study of the Summation of Flicker Caused by Wind Turbines

• Published in: Energies (Basel) 2019-06, Vol.12 (12), p.2404
• Main Authors: Redondo, Koldo, Gutiérrez, José Julio, Azcarate, Izaskun, Saiz, Purificación, Leturiondo, Luis Alberto, Ruiz de Gauna, Sofía
• Format: Article
• Language: English
• Subjects: Emission standards; Emissions; Energy; Equivalent circuits; Flicker; Industrial plant emissions; Laboratories; Methods; Power plants; power quality; Quality; Time series; Turbines; Variation; voltage fluctuations; Wind power; wind power plant; Wind speed
• ISSN: 1996-1073; 1996-1073
• DOI: 10.3390/en12122404

Integration of wind energy into the grid faces a great challenge regarding power quality. The International Electrotechnical Commission (IEC) 61400-21 standard defines the electrical characteristics that need to be assessed in a Wind Turbine (WT), as well as the procedure to measure the disturbances produced by the WT. One of the parameters to be assessed are voltage fluctuations or flicker. To estimate the flicker emission of a Wind Power Plant (WPP), the standard establishes that a quadratic exponent should be used in the summation of the flicker emission of each WT. This exponent was selected based on studies carried out in WPPs with type I and II WTs. Advances in wind turbine technology have reduced their flicker emission, mainly thanks to the implementation of power electronics for the partial or total management of the power injected into the grid. This work is based on measurements from a WPP with 16 type III WTs. The flicker emission of a single WT and of the WPP were calculated. Low flicker emission values at the Point of Common Coupling (PCC) of the WPP were obtained. The flicker estimation at the PCC, based on the measurement from a single WT, was analyzed using different exponents. The results show that a cubic summation performs better than the quadratic one in the estimation of the flicker emission of a WPP with type III WTs.