Microstructure and Properties of Laser Cladding AlxFeCoCrNiMn High Entropy Alloy of Q345 Steel

• Published in: Materials research (São Carlos, São Paulo, Brazil) São Paulo, Brazil), 2023-01, Vol.26, p.1
• Main Authors: Yan, Dongfang, Shi, Chuanwei, Wang, Jianyang, Zhang, Yuanbin, Sun, Junhua, Wang, Yongbin, Liu, Peng
• Format: Article
• Language: English
• Subjects: Aluminum; Atomic properties; Body centered cubic lattice; cladding layer; Corrosion resistance; Corrosive wear; ENGINEERING, CHEMICAL; Entropy; Face centered cubic lattice; Hardness; high entropy alloy; High entropy alloys; High strength low alloy steels; Laser beam cladding; MATERIALS SCIENCE, MULTIDISCIPLINARY; Metallurgy; METALLURGY & METALLURGICAL ENGINEERING; Microstructure; Solid phases; Solid solutions; Steel plates; Structural steels; Wear resistance
• ISSN: 1516-1439; 1980-5373; 1980-5373
• DOI: 10.1590/1980-5373-mr-2022-0154

High entropy alloy is a multi-component alloy material with equal or near atomic number, which has excellent wear resistance and corrosion resistance. In this paper, AlxFeCoCrNiMn (x = 0,0.5,1.0,1.5) high entropy alloy cladding layer was prepared by laser cladding on Q345 steel plate. The phase structure, microstructure, hardness and wear resistance of the cladding layer were studied. The results show that the cladding layer of AlxFeCoCrNiMn alloy has good metallurgical bonding ability with Q345 steel. The cladding area is mainly columnar and equiaxed. The cladding layer of AlxFeCoCrNiMn alloy is mainly composed of BCC + FCC solid solution phase, which is caused by the addition of Al element under the high entropy effect. Al element promotes the formation of BCC phase structure. With the increase of Al element, the hardness of cladding layer increases. The hardness of A1.0 cladding layer is 670HV, which is close to three times of Q345 steel. When Al (x = 1.0), the hardness of the cladding layer is the highest, and it also shows better wear resistance with lower friction and wear loss.