Does posterior configuration have similar strength as parallel configuration for treating comminuted distal humerus fractures? A cadaveric biomechanical study

• Published in: BMC musculoskeletal disorders 2021-05, Vol.22 (1), p.440-440, Article 440
• Main Authors: Shih, Chien-An, Kuan, Fa-Chuan, Hsu, Kai-Lan, Hong, Chih-Kai, Lin, Cheng-Li, Yeh, Ming-Long, Su, Wei-Ren
• Format: Article
• Language: English
• Subjects: Biomechanical study; Biomechanics; Bone marrow; Bone mineral density; Cadavers; Comminuted fracture; Compression; Distal humeral fracture; Elbow; Failure; Fracture fixation; Fractures; Humerus; Injuries; Internal fixation in fractures; Load; Mechanical properties; Methods; Parallel plating; Posterior plating; Titanium alloys
• ISSN: 1471-2474; 1471-2474
• DOI: 10.1186/s12891-021-04302-9

The posterior plating technique could be used as a clinical alternative to parallel plating for treating comminuted distal humerus fractures (DHFs) successfully with good clinical results. However, the biomechanical characteristics for posterior fixation are still unclear. The purpose of this study is to evaluate the biomechanical properties of the posterior fixation and to make comparisons between the parallel and the posterior fixation systems. We performed a cadaveric biomechanical testing with two posterior plating systems (a posterior two plating and a single posterior pre-contoured Y plating system) and one parallel two plating system to treat AO/OTA type-C2.3 DHFs. Among three groups, we compared construct stiffness, failure strength, and intercondylar width changes after 5000-cycle fatigue loading and failure loads and failure modes after destructive tests in both the axial compression and (sagittal) posterior bending directions. The correlations between construct failure loads and bone marrow density (BMD) were also compared. In axial direction, there were no significant differences in the stiffness and failure load between the posterior and the parallel constructs. However, in sagittal direction, the two-plate groups (posterior two plating and parallel plating group) had significant higher stiffness and failure loads than the one-plate group (single posterior Y plating). There was no fixation failure after 5000-cyclic loading in both directions for all groups. Positive correlation was noted between BMD and failure loads on parallel fixation. We found that when using two plates for treating comminuted DHFs, there were no significant differences in terms of most biomechanical measurements between posterior and parallel fixation. However, the single pre-contoured posterior Y plate construct was biomechanically weaker in the sagittal plane than the parallel and the posterior two-plate constructs, although there was no fixation failure after the fatigue test for all groups regardless of the fixation methods. Biomechanical study.