Mechanical, tribological, and morphological properties of SiC and Gr reinforced Al-0.7Fe-0.6Si-0.375Cr-0.25Zn based stir-casted hybrid metal matrix composites for automotive applications: Fabrication and characterizations

• Published in: Journal of materials research and technology 2024-01, Vol.28, p.3267-3285
• Main Authors: Garg, Harish K., Sharma, Shubham, Kumar, Rajesh, Manna, Alakesh, Dwivedi, Shashi Prakash, Abbas, Mohamed, Kumar, Abhinav, Khan, M. Ijaz, Bisht, Yashwant Singh
• Format: Article
• Language: English
• Subjects: Graphite particles; Micro-hardness test; Microstructure; Silicon carbide particles; Stir casting; Tensile strength; Tribological; XRD
• ISSN: 2238-7854
• DOI: 10.1016/j.jmrt.2023.12.171

The main goal of this research is to meet the demanding need for developing lightweight materials with improved properties that are appropriate for several engineering applications. The investigators proceeded to considerable efforts to assess the mechanical, micro-structural, and tribological characteristics of Al-0.7Fe-0.6Si-0.375Cr-0.25Zn/10 wt%SiCP/3 wt%GrP-MMC, Al-0.7Fe-0.6Si-0.375Cr-0.25Zn/15 wt%SiCP/5 wt%GrP-MMC, and Al-0.7Fe-0.6Si-0.375Cr-0.25Zn/20 wt%SiCP/8 wt%GrP-MMC based hybrid metal-matrix nano-composites (HMMC's). These hybrid aluminum matrix nano-composites were fabricated using the liquid processing stir casting method for automobile, aviation, defense, and chemical handling sectors owing to their superior strength, and higher thermal conductive properties. The machinability of Al-0.7Fe-0.6Si-0.375Cr-0.25Zn/(SiCp + Grp) - MMC has received limited attention to date. Owing to its exceptional characteristics, this hybrid composite could take the role of cast iron or aluminum composites in a wide-variety multitude of engineering applications. The Mechanical properties of fabricated Hybrid-MMCs have been examined along with tribological properties & other factors, affecting the tensile strength of cast composites in this study. Additionally, the characterization has been performed through X-ray Diffraction (XRD), Energy Dispersive Spectrum (EDS), Scanning Electron Microscope (SEM), and Optical Microscopy. The fabricated samples of hybrid metal matrix nano-composites of Al-0.7Fe-0.6Si-0.375Cr-0.25Zn matrix have been tested for microstructure analysis, micro hardness test, density, tensile strength, and grain size. Microstructure study clears the claim of uniform distribution of SiC & Graphite particles in Al matrix alloy. An average tensile strength has been recorded as 258 MPa and a percent-elongation of 4.6 during the tensile test. Tensile-fractography findings have portrayed the intrinsic fractured-rupture microstructure of tensile-tested samples that seemed to have particle deformation breakage and pull-outs. The density of Al/(SiCp + Grp)-MMCs have been found to be 2.76 g/cm3 whereas the average hardness has been recorded at 120HV. An increase in graphite content in Al/SiC-MMC's provides a significant improvement in friction coefficient as well as a reduction in wear rate. Findings have observed that the wear rate is increased with increasing the sliding speed, however, it is almost constant between 300 and 600 rpm, and beyond this wear rate