Understanding the Effect of Delay Time of Solvent Washing on the Performances of Perovskite Solar Cells

• Published in: ACS omega 2017-11, Vol.2 (11), p.7666-7671
• Main Authors: Zhang, Heyi, Niu, Qiaoli, Tang, Xiao, Wang, Huiping, Huang, Wentao, Xia, Ruidong, Zeng, Wenjin, Yao, Jizhong, Yan, Buyi
• Format: Article
• Language: English
• ISSN: 2470-1343; 2470-1343
• DOI: 10.1021/acsomega.7b01026

Uniform and dense perovskite films were realized by the one-step solution-processing method combined with toluene washing. The influence of the delay time applied for toluene washing on the film quality of CH3NH3PbI3 (MAPbI3) was investigated in a comprehensive manner. The optimal delay time was experimentally observed at the critical point when the color of the film changes from transparent to hazy. A detailed X-ray diffraction study suggested that such a color change was caused by the emergence of the MAPbI3 crystal nucleus. This finding provides a convenient method to determine the optimal time accurately. With the optimal delay time, the most uniformly distributed MAPbI3 grains with the largest average grain size and the smoothest surface were obtained. Owing to the realization of homogeneous MAPbI3 films combined with full coverage of perovskite on the substrate achieved by toluene washing at the critical point, open-circuit voltage, short-circuit current, fill factor, and power conversion efficiency of 1.11 V, 18.24 mA/cm2, 77.47, and 15.54% were obtained.