Effect of Chemical Composition of Metal-Organic Crosslinker on the Properties of Fracturing Fluid in High-Temperature Reservoir

• Published in: Molecules (Basel, Switzerland) Switzerland), 2024-06, Vol.29 (12), p.2798
• Main Authors: Shi, Shenglong, Sun, Jinsheng, Mu, Shanbo, Lv, Kaihe, Liu, Jingping, Bai, Yingrui, Wang, Jintang, Huang, Xianbin, Jin, Jiafeng, Li, Jian
• Format: Article
• Language: English
• Subjects: Acids; Aluminum; aluminum–zirconium crosslinker; Boron; chemical composition; Comparative analysis; Crosslinked polymers; Fluids; fracturing fluid; gelation mechanism; High temperature; Hydraulic fracturing; Lactic acid; Polyacrylamide; Polymers; Rheology; Salinity; Viscosity; Zirconium
• ISSN: 1420-3049; 1420-3049
• DOI: 10.3390/molecules29122798

To investigate the effect of the chemical composition of a metal-organic crosslinker on the performances of fracturing fluid in high-temperature conditions, four zirconium (Zr) crosslinkers and one aluminum-zirconium (Al-Zr) crosslinker with a polyacrylamide were used. The crosslinkers possessed the same Zr concentration, but they differed in component amounts and the order of the addition of the crosslinker components, leading to different chemical compositions in the crosslinkers. The fracturing fluids prepared by different tested crosslinkers were compared in terms of properties of rheological behavior, sand-carrying ability, microstructure, and gel breaking characteristics. The results showed that the fracturing fluids prepared by zirconium lactic acid, ethanediamine, and sorbitol crosslinkers offered the slowest viscosity development and highest final viscosity compared to the zirconium lactic acid crosslinker and the zirconium lactic acid and ethanediamine crosslinker. The zirconium sorbitol, lactic acid, and ethanediamine crosslinker exhibited a faster crosslinking rate and a higher final viscosity than the zirconium lactic acid, ethanediamine, and sorbitol crosslinker; the crosslinker showed crosslinking density and crosslinking reactivity, resulting in more crosslinking sites and a higher strength in the fracturing fluid. The Al-Zr-based crosslinker possessed better properties in temperature and shear resistance, viscoelasticity, shear recovery, and sand-carrying ability than the Zr-based crosslinker due to the synergistic crosslinking effect of aluminum and zirconium ions. The tertiary release gelation mechanism of the Al-Zr-based fracturing fluid achieved a temperature resistance performance in the form of continuous crosslinking, avoiding the excessive crosslinking dehydration and reducing viscosity loss caused by early shear damage. These results indicated that the chemical compositions of metal-organic crosslinkers were important factors in determining the properties of fracturing fluids. Therefore, the appropriate type of crosslinker could save costs without adding the additional components required for high-temperature reservoirs.