Characterization and modeling of mechanical behavior of quenching and partitioning steels

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Structural materials : properties, microstructure and processing, 2015-01, Vol.620, p.293-300
• Main Authors: Arlazarov, A., Bouaziz, O., Masse, J.P., Kegel, F.
• Format: Article
• Language: English
• Subjects: Chemical Sciences; Engineering Sciences; Evolution; Material chemistry; Mathematical models; Mechanical properties; Microstructure; Modeling; Partitioning; Quadratic programming; Quenching and Partitioning; Retained austenite; Structural steels; TRIP
• ISSN: 0921-5093; 1873-4936
• DOI: 10.1016/j.msea.2014.10.034

Q&P annealing was applied to cold rolled carbon–manganese steel with Si. Q&P cycles with different partitioning temperature and time were simulated and the evolution of microstructure and mechanical properties was investigated. All the microstructures were composed of three constituents: partitioned martensite, laths of retained austenite and MA islands. Fine microstructure characterization confirmed that C diffusion plays an important role for the stabilization of retained austenite at room temperature and further TRIP effect during mechanical loading. Good compromise between yield strength (~1200MPa) and uniform elongation (~11%) was found in the case of 400°C partitioning for 300s due to the enhanced mechanical stability of retained austenite. Evolution of microstructure and mechanical properties was discussed and some mechanisms were proposed to explain the observations. Mechanical model for the prediction of stress–strain curves of Q&P steels was proposed, based on the obtained experimental data. Accurate prediction of stress–strain curves using model was achieved.