Mechanical resistance behind fiber-reinforced polymer pile: Role of clay minerals

• Published in: Computers and geotechnics 2024-04, Vol.168, p.106158, Article 106158
• Main Authors: Wan, Jian-Hong, Zaoui, Ali
• Format: Article
• Language: English
• Subjects: Engineering Sciences; Epoxy; FRP pile; Interface friction; Kaolinite; Molecular dynamics
• ISSN: 0266-352X; 1873-7633
• DOI: 10.1016/j.compgeo.2024.106158

Due to the geotechnical design requirements of the fiber-reinforced polymer (FRP) pile embedded in clay, interface friction evolution between the FRP pile and clay plays a crucial role in determining the pile shaft resistance. It is observed from the experimental evaluation that the earth pressure and shear rate affect the pile-soil interface behavior. In this study, a cross-linked epoxy resin is created to contact a siloxane surface of kaolinite in the molecular dynamic simulation. The interfacial accommodation between kaolinite and epoxy resin is studied. In order to investigate the effect of normal stress and sliding velocity on nanoscale friction characteristics, the steered molecular dynamics is utilized to simulate the sliding of the kaolinite model on the surface of the epoxy resin. Simulation results show that the calculated peak interface shear coefficient decreases nonlinearly as the normal stress increases, which follows a logarithmic relationship consistent with the FRP-soil interface shear test. On the other hand, it is observed that two distinct velocity regions, slow pulling mode (5–200 m/s) and fast pulling modes (300–800 m/s), are well fitted by extended Bell theory. The stick–slip motion is only found in slow sliding velocity mode. This increasing tendency of the energy barrier with the normal stresses indicates that higher pulling forces are required for the FRP to slide along the soil at higher normal stress. The present work provides a fundamental understanding of the friction mechanisms between kaolinite and epoxy resin.