On the Prediction of Uniaxial Tensile Behavior Beyond the Yield Point of Wrought and Additively Manufactured Ti-6Al-4V

• Published in: Integrating materials and manufacturing innovation 2022, Vol.11 (3), p.327-338
• Main Authors: Quintana, Maria J., Temple, Andrew J., Harlow, D. Gary, Collins, Peter C.
• Format: Article
• Language: English
• Subjects: Additive manufacturing; Characterization and Evaluation of Materials; Chemistry and Materials Science; Electron beams; Heat treatment; Kocks–Mecking–Estrin model; Laser beam melting; Manufacturing; MATERIALS SCIENCE; mechanical properties; Metallic Materials; Nanotechnology; Parameters; Stress-strain curves; Structural Materials; Surfaces and Interfaces; Technical Article; Tensile strength; Thin Films; Three dimensional printing; Ti-6Al-4V; titanium; Titanium base alloys; True strain; True stress; Ultimate tensile strength; work hardening; Yield point
• ISSN: 2193-9764; 2193-9772
• DOI: 10.1007/s40192-022-00265-4

In this paper, phenomenological relationships are presented that permit the prediction of the plastic regime of stress–strain curves using a limited number of parameters. These relationships were obtained from both conventional (wrought + β annealed) and additively manufactured (i.e., “3D printed”) Ti-6Al-4V. Three different methods of additive manufacturing have been exploited to produce the materials, including large-volume electron beam additive manufacturing, large-volume laser hot wire additive manufacturing, and small-volume selective laser melting. The general fundamental expressions are independent not only of the additive manufacturing process, but also of a wide variety of post-deposition heat treatments, however the coefficients are specific to material states. Thus, this work demonstrates that it is possible to predict not only the ultimate tensile strength, but also the full true stress, true strain curves, if certain parameters of the material are known. In general, the prediction of ultimate tensile strength are within 5% of the experimentally measured values across all additive manufacturing variants and subsequent heat treatments. The absolute values of ultimate tensile strength range from ~ 910 MPa to ~ 1170 MPa for the single alloy Ti-6Al-4V. Data representing 113 explicit samples are included in this work.