Design of a Single-Ion Conducting Polymer Electrolyte for Sodium-Ion Batteries

• Published in: Journal of the Electrochemical Society 2021-12, Vol.168 (12), p.120543
• Main Authors: Liu, Kewei, Xie, Yingying, Yang, Zhenzhen, Kim, Hong-Keun, Dzwiniel, Trevor L., Yang, Jianzhong, Xiong, Hui, Liao, Chen
• Format: Article
• Language: English
• Subjects: ENERGY STORAGE; sodium ion batteries
• ISSN: 0013-4651; 1945-7111
• DOI: 10.1149/1945-7111/ac42f2

A sodium bis(fluoroallyl)malonato borate salt (NaBFMB) is synthesized. Using a Click thiol-ene reaction, NaBFMB can be photo-crosslinked with a tri-thiol (trimethylolpropane tris(3-mercapto propionate), TMPT) to create a single-ion conducting electrolyte (NaSIE), with all negative charges residing on the borate moieties and anions immobilized through the 3-D crosslinked network. The NaSIE can be prepared either as a free-standing film or through a drop-cast method followed by a photo crosslinking method for an in-situ formation on top of the electrodes. The free-standing film of NaSIE has a high ionic conductivity of 2 × 10 −3 S cm −1 at 30 °C, and a high transference number (t Na + ) of 0.91 as measured through the Bruce-Vincent method. The electrochemical stability of NaSIE polymer electrolyte is demonstrated via cyclic voltammetry (CV) to be stable up to 5 V vs Na/Na + . When tested inside a symmetrical Na//Na cell, the NaSIE shows a critical current density (CCD) of 0.4 mA cm −2 . The stability of NaSIE is further demonstrated via a long cycling of the stripping/plating test with a current density of 0.1 mA cm −2 at five-minute intervals for over 10,000 min. Using the in-situ method, NaSIE is used as the electrolyte for a sodium metal battery using P2 (Na resides at prismatic sites with with ABBAAB stacking)-cathode of Na 0.67 Ni 0.33 Mn 0.67 O 2 (NNMO) and is cycled between the cut-off voltages of 2.0–4.0 V. A high initial specific capacity (85.7 mAh g −1 ) with a capacity retention of 86.79% after 150 cycles is obtained.