A polymeric piezoelectric micropump based on lamination technology

• Published in: Journal of micromechanics and microengineering 2004-04, Vol.14 (4), p.632-638
• Main Authors: Truong, Thai-Quang, Nguyen, Nam-Trung
• Format: Article
• Language: English
• Subjects: Applied sciences; Exact sciences and technology; Instruments, apparatus, components and techniques common to several branches of physics and astronomy; Mechanical engineering. Machine design; Mechanical instruments, equipment and techniques; Micromechanical devices and systems; Physics; Precision engineering, watch making
• ISSN: 0960-1317; 1361-6439
• DOI: 10.1088/0960-1317/14/4/026

This paper presents the first micropumps assembled using polymeric lamination technology. Each pump consists of two 100 mum thick, 10 mm diameter SU-8 discs; two 1.5 mm thick, 15 mm diameter polymethylmethacrylate (PMMA) discs; and one piezo disc. The SU-8 parts were fabricated by a two-mask polymeric surface micromachining process with silicon as the sacrificial material. Each SU-8 disc has one micro check valve. The valve is a 1 mm plate suspended on a compliant orthoplanar spring. The cross section of the spring beam has a dimension of 100 mum X 100 mum. The PMMA parts were machined from an extrusion PMMA sheet by CO2 laser. An off-the-shelf piezo bimorph disc worked as both actuator and pump membrane. The pump was assembled using adhesive bonding. The adhesive tapes were cut by the same laser system. Alignment pins were used in the assembly process. With a drive voltage of +/-150 V the fabricated micropumps have been able to provide flow rates up to 2.9 ml min-1 and back pressures up to 1.6 m of water. The pump design and the polymeric technologies prove the feasibility of making more complex microfluidic systems based on the presented lamination approach.