Effects of using (Ti,Mo)C particles to reduce the three-body abrasive wear of a low alloy steel

• Published in: Wear 2018-09, Vol.410-411, p.119-126
• Main Authors: Huang, Long, Deng, Xiangtao, Jia, Ye, Li, Chengru, Wang, Zhaodong
• Format: Article
• Language: English
• Subjects: (TiMo)C reinforced; Abrasion resistant alloys; Abrasion resistant steels; Abrasive wear; Alloys; Cutting resistance; Cutting wear; Hardness testing; Load resistance; Low alloy steel; Low alloy steels; Machinability; Martensitic stainless steels; Microparticles; Molybdenum; Particles; Rubber; Steel; Titanium; Wear mechanism; Wear mechanisms; Wear resistance
• ISSN: 0043-1648; 1873-2577
• DOI: 10.1016/j.wear.2018.06.008

The use of high-grade, low alloy abrasion resistant steels has been limited due to the effects of their high hardness on their formability, machinability, and weldability. In order to increase the wear resistance of the steel without increasing hardness, a new low alloy wear resistant steel reinforced with (Ti,Mo)C particles was developed. The three-body abrasive wear behaviour of the experimental steel has been studied using a standard dry sand rubber wheel wear testing procedure under applied loads of 45 N and 130 N. Experimental observations revealed that nano- and microparticles are uniformly distributed in the martensitic matrix. The analysis of worn surfaces including longitudinal sections of the surfaces showed that the particles can effectively resist micro-cutting, due to which, the main wear mechanism of the experimental steel was through formation of pits and other indications of surface fatigues. Typically, the abrasion resistance of the experimental steel reinforced with particles was, respectively, 1.6 and 1.8 times that of a traditional low alloy wear resistant steel under applied loads of 130 N and 45 N. •Three types of particles with different sizes were found uniformly distributed in (Ti,Mo)C-reinforced steel.•The wear resistance of (Ti,Mo)C-reinforced steel was improved to 1.8 times that of traditional NM500.•The particles distributed in the matrix effectively resisted micro-cutting and thereby improved wear resistance.•The wear mechanism of (Ti,Mo)C-reinforced steel was through formation of pits and other indications of surface fatigues.