Design and proof of concept of an innovative very high temperature ceramic solar absorber

• Main Authors: Leray, Cédric, Ferriere, Alain, Toutant, Adrien, Olalde, Gabriel, Peroy, Jean-Yves, Chéreau, Patrick, Ferrato, Marc
• Format: Conference Proceeding
• Language: English
• Subjects: Computer simulation; Gas turbine engines; High temperature; Market penetration; Mechanical properties; Modular design; Silicon carbide; Solar energy absorbers; Solar flux density; Temperature gradients; Thermomechanical properties
• ISSN: 0094-243X; 1551-7616
• DOI: 10.1063/1.4984375

Hybrid solar gas-turbine (HSGT) is an attractive technology to foster market penetration of CSP. HSGT offers some major advantages like for example high solar-to-electric conversion efficiency, reduced water requirement and low capital cost. A very high temperature solar receiver is needed when elevated solar share is claimed. A few research works, as reported by Karni et al. [8] and by Buck et al. [1], have been dedicated to solar receiver technologies able to deliver pressurized air at temperature above 750°C. The present work focuses on research aiming at developing an efficient and reliable solar absorber able to provide pressurized air at temperature up to 1000°C and more. A surface absorber technology is selected and a modular design of receiver is proposed in which each absorber module is made of BOOSTEC® SiC ceramic (silicon carbide) as bulk material with straight air channels inside. Early stage experimental works done at CNRS/PROMES on lab-scale absorbers showed that the thermo-mechanical behavior of this material is a critical issue, resulting in elevated probability of failure under severe conditions like large temperature gradient or steep variation of solar flux density in situations of cloud covering. This paper reports on recent progress made at CNRS/PROMES to address this critical issue. The design of the absorber has been revised and optimized according to thermo-mechanical numerical simulations, and an experimental proof of concept has been done on a pilot-scale absorber module at Themis solar tower facility.