Comparative analysis of the effects of tantalum doping and annealing on atomic layer deposited (Ta2O5) x (Al2O3)1− x as potential gate dielectrics for GaN/AlxGa1−xN/GaN high electron mobility transistors

• Published in: Journal of applied physics 2016-01, Vol.119 (2)
• Main Authors: Partida-Manzanera, T., Roberts, J. W., Bhat, T. N., Zhang, Z., Tan, H. R., Dolmanan, S. B., Sedghi, N., Tripathy, S., Potter, R. J.
• Format: Article
• Language: English
• Subjects: Aluminum oxide; Annealing; Applied physics; Atomic layer epitaxy; Conduction bands; Defect annealing; Dielectric properties; Dielectrics; Electrical measurement; Energy gap; High electron mobility transistors; Interfacial properties; Offsets; Oxide coatings; Permittivity; Reduction; Semiconductor devices; Tantalum; Tantalum oxides; Thin films
• ISSN: 0021-8979; 1089-7550
• DOI: 10.1063/1.4939298

This paper describes a method to optimally combine wide band gap Al2O3 with high dielectric constant (high-κ) Ta2O5 for gate dielectric applications. (Ta2O5)x(Al2O3)1−x thin films deposited by thermal atomic layer deposition (ALD) on GaN-capped AlxGa1−xN/GaN high electron mobility transistor (HEMT) structures have been studied as a function of the Ta2O5 molar fraction. X-ray photoelectron spectroscopy shows that the bandgap of the oxide films linearly decreases from 6.5 eV for pure Al2O3 to 4.6 eV for pure Ta2O5. The dielectric constant calculated from capacitance-voltage measurements also increases linearly from 7.8 for Al2O3 up to 25.6 for Ta2O5. The effect of post-deposition annealing in N2 at 600 °C on the interfacial properties of undoped Al2O3 and Ta-doped (Ta2O5)0.12(Al2O3)0.88 films grown on GaN-HEMTs has been investigated. These conditions are analogous to the conditions used for source/drain contact formation in gate-first HEMT technology. A reduction of the Ga-O to Ga-N bond ratios at the oxide/HEMT interfaces is observed after annealing, which is attributed to a reduction of interstitial oxygen-related defects. As a result, the conduction band offsets (CBOs) of the Al2O3/GaN-HEMT and (Ta2O5)0.16(Al2O3)0.84/GaN-HEMT samples increased by ∼1.1 eV to 2.8 eV and 2.6 eV, respectively, which is advantageous for n-type HEMTs. The results demonstrate that ALD of Ta-doped Al2O3 can be used to control the properties of the gate dielectric, allowing the κ-value to be increased, while still maintaining a sufficient CBO to the GaN-HEMT structure for low leakage currents.