Microwave vs conventional porcelain firing: Macroscopic properties

• Published in: International journal of applied ceramic technology 2020-09, Vol.17 (5), p.2277-2285
• Main Authors: Santos, Tiago, Hennetier, Luc, Costa, Vítor A. F., Costa, Luis C.
• Format: Article
• Language: English
• Subjects: apparent porosity; Bulk density; Eutectic temperature; Firing; Impact analysis; Impact resistance; Magnetrons; microwave heating; Physical properties; Porcelain; porcelain firing; Porosity; Room temperature; Tableware; Temperature; Temperature dependence; Water absorption
• ISSN: 1546-542X; 1744-7402
• DOI: 10.1111/ijac.13569

This paper provides an overview of the macroscopic properties of porcelain tableware fired in a microwave furnace with six magnetrons (each with a nominal power of 900 W) operating at the frequency of 2.45 GHz. The dependence of firing temperature on physical properties such as shrinkage, water absorption, apparent porosity, bulk density, and impact resistance was analyzed. Emphasis is on the differences in the macroscopic properties of microwave and conventionally (gas and electric) fired porcelain. Batches were fired from room temperature up to above the optimum firing temperature (1380°C). Results show similar macroscopic properties for both firing methods, microwave heating required lower firing temperatures (between 1300°C and 1350°C), and shorter processing times (about 70 minutes). The main differences between microwave and electric firing methods occur in a temperature band of 300°C above the porcelain eutectic temperature (close to 1000°C).