The Interface Zone of Explosively Welded Titanium/Steel after Short-Term Heat Treatment

• Published in: Metallurgical and materials transactions. A, Physical metallurgy and materials science Physical metallurgy and materials science, 2021-05, Vol.52 (5), p.1588-1595
• Main Authors: Szmul, Marcin, Stan-Glowinska, Katarzyna, Janusz-Skuza, Marta, Bigos, Agnieszka, Chudzio, Andrzej, Szulc, Zygmunt, Wojewoda-Budka, Joanna
• Format: Article
• Language: English
• Subjects: Annealing; Characterization and Evaluation of Materials; Chemistry and Materials Science; Explosive welding; Heat treating; Heat treatment; Interlayers; Intermetallic phases; Iron; Materials Science; Metallic Materials; Microhardness; Microstructure; Nanotechnology; Original Research Article; Plastic properties; Structural Materials; Surfaces and Interfaces; Thin Films; Titanium carbide; Welded joints
• ISSN: 1073-5623; 1543-1940
• DOI: 10.1007/s11661-021-06174-z

This work presents a detailed description of a bonding zone of explosively welded Ti/steel clads subjected to stress relief annealing, applied in order to improve the plasticity of the final product. The typical joint formed by the welding process possesses a characteristic wavy interface with melted regions observed mainly at the crest regions of waves. The interface of Ti/steel clads before and after annealing was previously investigated mostly in respect to the melted regions. Here, a sharp interface between the waves was analyzed in detail. The obtained results indicate that the microstructure of a transition zone of that area is different along the width. After the heat treatment at 600 °C for 1.5 hours, titanium carbide (TiC) together with α -Fe phase forms at the interface in local areas of relatively wide interlayer (~ 1  µ m), while for most of the sharp interface, a much thinner zone up to about 400 nm, formed by four sublayers containing intermetallic phase and carbides, is present. This confirms that carbon diffusion induced by applied heat treatment significantly influences the final microstructure of the Ti/steel interface zone. Side bending tests confirmed high plasticity of welds after applied heat treatment; however, the microhardness measurements indicated that the strengthening of the steel in the vicinity of the interface had not been removed completely.