Effect of Ion Energy on the Microstructure and Properties of Titanium Nitride Thin Films Deposited by High Power Pulsed Magnetron Sputtering

• Published in: Coatings (Basel) 2021-05, Vol.11 (5), p.579
• Main Authors: Ma, Donglin, Deng, Qiaoyuan, Liu, Huaiyuan, Leng, Yongxiang
• Format: Article
• Language: English
• Subjects: Adhesive strength; Corrosion resistance; Cutting resistance; Cutting tools; Cutting wear; Energy; Grain size; Magnetron sputtering; Microscopy; Microstructure; Nitrogen; Plasma; Poisoning; Residual stress; Silicon wafers; Substrates; Surface roughness; Surgical implants; Thin films; Titanium compounds; Titanium nitride; Tool wear; Wear resistance
• ISSN: 2079-6412; 2079-6412
• DOI: 10.3390/coatings11050579

Titanium nitride (Ti-N) thin films are electrically and thermally conductive and have high hardness and corrosion resistance. Dense and defect-free Ti-N thin films have been widely used in the surface modification of cutting tools, wear resistance components, medical implantation devices, and microelectronics. In this study, Ti-N thin films were deposited by high power pulsed magnetron sputtering (HPPMS) and their plasma characteristics were analyzed. The ion energy of Ti species was varied by adjusting the substrate bias voltage, and its effect on the microstructure, residual stress, and adhesion of the thin films were studied. The results show that after the introduction of nitrogen gas, a Ti-N compound layer was formed on the surface of the Ti target, which resulted in an increase in the Ti target discharge peak power. In addition, the total flux of the Ti species decreased, and the ratio of the Ti ions increased. The Ti-N thin film deposited by HPPMS was dense and defect-free. When the energy of the Ti ions was increased, the grain size and surface roughness of the Ti-N film decreased, the residual stress increased, and the adhesion strength of the Ti-N thin film decreased.