The proposed improvements to minimize potential failures using lean six sigma and multi attribute failure mode analysis approaches

• Published in: IOP conference series. Materials Science and Engineering 2019-12, Vol.673 (1), p.12082
• Main Authors: Ulfah, M, Trenggonowati, D L, Ekawati, R, Ramadhania, S
• Format: Article
• Language: English
• Subjects: Analytic hierarchy process; Coils; Cold rolling; Cost analysis; Edge cracks; Failure; Failure analysis; Failure modes; Iron and steel industry; Specifications; Steel making
• ISSN: 1757-8981; 1757-899X
• DOI: 10.1088/1757-899X/673/1/012082

PT X is the largest steel industry in Indonesia. During the production process, still have large quantities of waste defect. The purpose of this research is to determine the waste that occurs in the production process, determine the characteristics of deformity or critical to quality (CTQ), determine the sigma value, determine the factors that caused the failure of the production process, and determine the proposed improvement to minimize the failure of the production process. The most dominant types of defects are serrated edge, wavy edge, poor cleanliness, pick up, edge crack, ripple edge, and bad weld. The sigma value of cold rolled coil product is 4, 131 which is included into the industry average of USA (± 4σ). Factors that caused cold rolled coil production process failed based on criteria severity, occurrence, detection, and expected costs by Fuzzy Analytical Hierarchy Process (F-AHP) is material imported from outside with a total weight of 0.087. Proposed improvements done to minimize failure in cold rolled coil production processes are doing trial for products from HSM factory to test or know the slab specifications related to the chemical constituents of steelmaking and adjusting the format (such as thickness, length, width) and steel specifications to corresponding.