The Properties of OPEFB Cellulose Nanofibrils Produced by A Different Mode of Ultrafine Grinding

• Published in: IOP conference series. Earth and environmental science 2021-11, Vol.891 (1), p.12016
• Main Authors: Amanda, P, Nabila, S, Qonita, N, Ningrum, R S, Ismadi, Masruchin, N
• Format: Article
• Language: English
• Subjects: Bleaching; Cellulose; Crystal structure; Crystallinity; Fibrillation; Grinding; Kraft pulp; Micrography; Particle size distribution; Photomicrographs; Pulp; Scanning electron microscopy; Size distribution; Structural hierarchy; Ultrafines
• ISSN: 1755-1307; 1755-1315
• DOI: 10.1088/1755-1315/891/1/012016

Cellulose Nanofibrils (CNFs) was resulted from deconstruction of the hierarchical structure of cellulose. CNFs are commonly obtained by mechanical fibrillation, such as ultrafine grinding processes and its variation. Nevertheless, the influence of different treatments on the properties of the resulting CNF especially from variety of ultrafine grinding mode has not been reported. This study investigates the properties of cellulose nanofibrils (CNF) produced from bleached pulp oil palm empty fruit bunch (OPEFB) Kraft pulp through an ultrafine grinder with two different treatments in the fibrillation process. These two treatments were: 1) ultrafine grinder with increasing gaps distances; -30, -50, -70, and -90 µm with five cycles in every gap, 2) ultrafine grinder on constant gaps (-30µm) with increasing grinding cycles: 5, 10, 15, 30, and 40 cycles through the grinder. The influence of the treatment was evaluated through particle size distribution, crystallinity index, and morphological properties. The result showed that the increasing gaps treatment efficiently improved the size uniformity of CNFs, length 147-139.5 nm, and scanning electron microscope micrograph confirmed that the diameter of CNF was smaller with the increasing grinding gaps than increasing grinding cycles. However, the increasing cycle’s treatment produced CNF with a higher crystallinity index. The crystallinity index (CrI) of the CNF decreased from 71.27 to 62.25% with increasing gaps, whereas the CrI of the CNF from increasing cycles was 69.35%. This study provides a valuable guideline for determining the appropriate process to produce CNF especially by mechanical grinding using ultrafine grinder from OPEFB according to the desired result.