Experimental research on the wall-wetting effects on the frictional property of the cylinder liner–piston ring pair

• Published in: Proceedings of the Institution of Mechanical Engineers. Part J, Journal of engineering tribology Journal of engineering tribology, 2022-04, Vol.236 (4), p.721-731
• Main Authors: Xu, Bo, Yin, Bifeng, Jia, Hekun, Wei, Mingliang, Shi, Kunpeng
• Format: Article
• Language: English
• Subjects: Bearing capacity; Boundary lubrication; Coefficient of friction; Contact angle; Cylinder liners; Diesel fuels; Dilution; Friction; Lubricants; Lubricants & lubrication; Lubricating oils; Lubrication; Mechanical engineering; Piston rings; Tribology; Viscosity; Wettability; Wetting
• ISSN: 1350-6501; 2041-305X
• DOI: 10.1177/13506501211024010

The application of novel injection strategies (high-pressure injection, early injection, retarded injection, etc.) in combustion engines has made the wall-wetting problem severer. As the splashed fuel dilutes the lubricating oil, the tribological performance of the cylinder liner–piston ring pair will be affected. In this research, the viscosity and wettability tests were conducted firstly by mixing diesel into lubrication oil. It was found that the dynamic viscosity of the mixture drops with more fuel diluting the oil, and a small quantity of diesel mixed will cause a remarkable decline in lubricant viscosity; also, the contact angle shows a downward trend with the increasing diluting ratio. Then based on several typical diluting ratios, the reciprocating friction tests were carried out to measure the instantaneous friction force of the production ring/liner pair. The experimental results showed that under a mixed lubrication state, the peak friction force of the ring/liner pair occurs around the dead centers, while the minimum force occurs at the middle position of the reciprocating stroke; with more fuel diluting the oil, the bearing capacity of oil film degrades, resulting in the increase of friction force. In addition, the average friction coefficient of the ring/liner pair shows an upward trend with the increasing diluting ratio, and the Stribeck curve moves toward the upper-left, which means the lubrication condition of this pair tends to transit from mixed lubrication to boundary lubrication, causing negative effects on the frictional property of the cylinder liner–piston ring pair. Therefore, the diluting ratio should be controlled under 20%.