Vibration Response of the Interfaces in Multi-Layer Combined Coal and Rock Mass under Impact Load

• Published in: Processes 2023-02, Vol.11 (2), p.306
• Main Authors: Li, Feng, Wang, Guanghao, Xiang, Guangyou, Tang, Jia, Ren, Baorui, Chen, Zhibang
• Format: Article
• Language: English
• Subjects: Amplitudes; Attenuation; Coal; Coal gas outbursts; Disasters; Dynamic loads; Dynamic response; Experiments; Extreme values; Fast Fourier transformations; Hilbert transformation; Impact damage; Impact loads; Interfaces; Load; Mechanical properties; Mining; Mudstone; Multilayers; Mutation; Rock masses; Sandstone; Sensors; Simulation; Stress propagation; Stress waves; Vibration; Vibration mode; Vibration response
• ISSN: 2227-9717; 2227-9717
• DOI: 10.3390/pr11020306

The stress wave generated by impact or dynamic load will produce significant reflection and transmission at the rock coal or rock interface during the propagation process. This will produce dynamic effects such as dynamic tensile, stress superposition and mutation. These dynamic effects will lead to obvious vibration at the interfaces, which is a key factor leading to dynamic damage and the failure of coal and rock mass. In the process of underground engineering excavation, the dynamic damage of a series of layered rock masses is one of the important factors causing geological disasters. Based on the two–dimensional similar material simulation experiment, the coal and rock mass combined of five layers of fine sandstone, medium sandstone, coal, coarse sandstone and mudstone was taken as the research object, and single and multi-point excitation (synchronous/step-by-step) were used to test the time–history vibration curves of rock–coal and rock–rock interfaces under impact load. It was concluded that the change of extreme value of vibration amplitude presented two stages: first increase, and then attenuation. Most of them required 2.25 cycles to reach the peak value, and the dynamic attenuation of amplitude conformed to the law of exponential. Based on Fast Fourier transform (FFT), the spectrum structures of the amplitude–frequency of interface vibration were studied, and the two predominant frequencies were 48.9~53.7 Hz and 92.4 Hz, respectively. Based on the Hilbert-Huang transform and energy equation, 5~7 vibration modes (IMF) were obtained by decomposing the time–history curves. The three modes, IMF1, IMF2, and IMF3, contained high energy and were effective vibration modes. IMF2 accounted for the highest proportion and was the main vibration mode whose predominant frequencies were concentrated in 45.6~50.2 Hz. Therefore, IMF2 played a decisive role in the whole vibration process and had an important impact on the dynamic response, damage and failure of coal and rock mass. In real conditions, the actual predominant frequencies can be converted according to the size and mechanical properties of the coal and rock mass, and the vibration response characteristics of the interfaces between coal and rock mass under impact load were preliminarily revealed. This study can provide reference for monitoring and early warning of coal and rock dynamic disasters, prevention and control of coal and gas outburst and technical development.