Optimization of drilling parameters on delamination and burr formation in drilling of neat CFRP and hybrid CFRP nano-composites

• Published in: Materials research express 2024-03, Vol.11 (3), p.35006
• Main Authors: Shahabaz, S M, Shetty, Nagaraja, Sharma, Sathyashankara, P K, Jayashree, Shetty, S Divakara, Naik, Nithesh
• Format: Article
• Language: English
• Subjects: Aluminum oxide; burr formation; Carbon fiber reinforced plastics; CFRP; Contours; Coring; Damage; Damping capacity; Delamination; Diameters; Drilling; Drills; Fiber composites; Fiber reinforced polymers; Impact analysis; Nanocomposites; Optical microscopes; Process parameters; Response surface methodology; Surface properties; Surface roughness; Twist drills; Variance analysis
• ISSN: 2053-1591; 2053-1591
• DOI: 10.1088/2053-1591/ad3522

Carbon fibre-reinforced polymer (CFRP) composites have exceptional mechanical advantages such as high specific strength and stiffness, lightweight, and high damping capacity, making them very attractive for aircraft, aerospace, automotive, marine, and sporting applications. However, various defects such as delamination, burr formation, and surface roughness are observed during the drilling of CFRP composites, which are influenced by various drilling process parameters. In this work, the drilling quality of uni-directional CFRP composites. and the hybrid Al 2 O 3 and hybrid SiC nano-composites are investigated experimentally using different types of drills such as step drill, core drill, and twist drill, as there is a limited study done on the comparative analysis of the impact of the above drills on the delamination factor and burr area on the above CFRP and hybrid nano-composites. The design of the experiment table was developed using response surface methodology (RSM) for input process parameters of spindle speed, feed, drill diameter, and drill type. The output surface characteristics (delamination factor and burr area) of the hole were measured quantitatively using the stereo zoom optical microscope. The main effect plots, contour plots, and analysis of variance (ANOVA) were used to examine the effect of spindle speed, feed, drill diameter, and drill type on exit delamination and burr formation. The analysis of main effect plots, contour plots, and analysis of variance showcased the optimum process parameters, such as a high spindle speed of 5500 rpm, low feed of 0.01 mm/rev, and drill diameter of 4 mm. The step drill demonstrated the least damage mechanism among drill geometries, followed by the twist and core drills. The minimum drilling damage was observed for the Al 2 O 3 hybrid nano-composite compared to the neat CFRP composites.