Peak Stir Zone Temperatures during Friction Stir Processing

• Published in: Metallurgical and materials transactions. A, Physical metallurgy and materials science Physical metallurgy and materials science, 2010-03, Vol.41 (3), p.631-640
• Main Authors: Swaminathan, Srinivasan, Oh-Ishi, Keiichiro, Zhilyaev, Alexander P., Fuller, Christian B., London, Blair, Mahoney, Murray W., McNelley, Terry R.
• Format: Article
• Language: English
• Subjects: Alloys; Characterization and Evaluation of Materials; Chemistry and Materials Science; Friction stir welding; Materials Science; Mechanical properties; Metallic Materials; Metallurgy; Microstructure; Nanotechnology; Solid solutions; Structural Materials; Surfaces and Interfaces; Temperature; Thin Films
• ISSN: 1073-5623; 1543-1940
• DOI: 10.1007/s11661-009-0140-7

The stir zone (SZ) temperature cycle was measured during the friction stir processing (FSP) of NiAl bronze plates. The FSP was conducted using a tool design with a smooth concave shoulder and a 12.7-mm step-spiral pin. Temperature sensing was accomplished using sheathed thermocouples embedded in the tool path within the plates, while simultaneous optical pyrometry measurements of surface temperatures were also obtained. Peak SZ temperatures were 990 °C to 1015 °C (0.90 to 0.97 T Melt ) and were not affected by preheating to 400 °C, although the dwell time above 900 °C was increased by the preheating. Thermocouple data suggested little variation in peak temperature across the SZ, although thermocouples initially located on the advancing sides and at the centerlines of the tool traverses were displaced to the retreating sides, precluding direct assessment of the temperature variation across the SZ. Microstructure-based estimates of local peak SZ temperatures have been made on these and on other similarly processed materials. Altogether, the peak-temperature determinations from these different measurement techniques are in close agreement.