Thermal response in thermal energy storage material around heat transfer tubes: effect of additives on heat transfer rates

• Published in: Solar energy 2003-01, Vol.75 (4), p.317-328
• Main Authors: Hamada, Yuichi, Ohtsu, Wataru, Fukai, Jun
• Format: Article
• Language: English
• Subjects: Additives; Applied sciences; Energy; Energy. Thermal use of fuels; Exact sciences and technology; Heat transfer; Solar energy; Sustainable materials; Thermal energy; Transport and storage of energy
• ISSN: 0038-092X; 1471-1257
• DOI: 10.1016/j.solener.2003.07.028

The effects of carbon-fiber chips and carbon brushes as additives on the thermal conductivity enhancement of phase change materials (PCMs) using in latent heat thermal energy storage are investigated experimentally and numerically by considering the wall effect of the additives. The carbon-fiber chips are effective for improving the heat transfer rate in PCMs. However, the thermal resistance near the heat transfer surface is higher than that for the carbon brushes. As a result, the overall heat transfer rate for the fiber chips is lower than that for the carbon brushes. Consequently, the carbon brushes are superior to the fiber chips for the thermal conductivity enhancement under the present experimental conditions. The carbon brushes are moreover applied to the packed beds of particles to overcome their low thermal conductivity in chemical heat pump/storage. The carbon brushes essentially improve the heat transfer characteristics in the packed beds, though the thermal resistance is observed because the particles obstruct contact between the fibers and the heat transfer surfaces.