Analysis of the influence of operating conditions on fouling rates in fired heaters

• Published in: Applied thermal engineering 2014, Vol.62 (2), p.777-784
• Main Authors: Morales-Fuentes, A., Picón-Núñez, M., Polley, G.T., Méndez-Díaz, S.
• Format: Article
• Language: English
• Subjects: Applied sciences; Convection; Crude oil; Crude oil, natural gas and petroleum products; Crude oil, natural gas, oil shales producing equipements and methods; Energy; Energy. Thermal use of fuels; Enhanced oil recovery methods; Exact sciences and technology; Fired heater; Fouling; Fouling rates; Fuels; Heat transfer; Heaters; Heating equipment; Mathematical models; Process conditions; Prospecting and production of crude oil, natural gas, oil shales and tar sands; Steam injection; Theoretical studies. Data and constants. Metering; Trains
• ISSN: 1359-4311
• DOI: 10.1016/j.applthermaleng.2013.10.016

Fouling due to chemical reaction in preheat trains for the processing of crude oil plays a key role in the operation and maintenance costs and on greenhouse emissions to atmosphere in crude processing plants. A preheat train consists of a set of heat transfer units that provide the crude oil stream the required amount of thermal energy to reach its target temperature either by heat recovery or by direct firing. Fired heaters supply external high temperature heating through the burning of fuel which result in complex heat transfer processes due to the large temperature and pressure changes and vaporization that takes place inside the unit. In this work, a thermo-hydraulic analysis of the performance of fired heaters is carried out through the application of commercial software to solve the mathematical models using finite difference methods; the analysis is applied to the crude side of a vertical fired heater in order to evaluate the impact of process conditions such as throughput and crude inlet temperature (CIT) on the fouling that take place at the early stages of operation. Using a fouling rate model based on thermo-hydraulic parameters, fouling rates are predicted assuming steady state operation and clean conditions. Although variations in process conditions are known to influence fouling rates, little work has been done on the subject. In this work excess air and steam injection are studied as a means to mitigate fouling. Results show that throughput reduction brings about a marked increase in the fouling rates. A decrease in CIT affects only the convection zone and it is found that this effect is negligible. In terms of excess air, it is found that although it affects negatively the heater efficiency it can be used to balance heat transfer between the convection and radiation zone in a way that fouling rates are reduced; however this strategy should be considered right from the design stage. Finally it is observed that steam injection is an effective method to reduce fouling rates since it results in lower film temperatures and larger shear stress. •Local fouling rates using thermo-hydraulic parameters are evaluated in a fired heater.•The effect of throughput, excess air and inlet temperature upon fouling rate is analyzed along the crude path.•Performance of the fired heater for specific conditions is presented showing overall operation data.•Film temperature and wall shear stress plots as parameters dictating the deposition and removal rates are pre