Mechanical damping in nanostructured Nd sub(60)Fe sub(30)Al sub(10) magnetic alloys

• Published in: Journal of alloys and compounds 2010-04, Vol.495 (2), p.420-422
• Main Authors: Salva, H R, Fabietti, L M, Ghilarducci, A A, Urreta, SE
• Format: Article
• Language: English
• Subjects: Alloys; Damping; Magnetic alloys; Melt spinning; Modulus of elasticity; Nanostructure; Storage modulus; Stress relaxation
• ISSN: 0925-8388
• DOI: 10.1016/j.jallcom.2009.10.012

Nanostructured Nd sub(60)Fe sub(30)Al sub(10) magnetic alloys were obtained by melt spinning at a tangential wheel speed of 5 m/s. Magnetic and stress relaxation processes were investigated in the as cast condition. Low frequency mechanical spectroscopy studies (dynamic elastic torsion modulus and internal damping measurements) were conducted at fixed frequencies between 0.1 and 1 Hz, in the range [150-480 K]. The low temperature internal damping and dynamic elastic modulus exhibited a large heating-cooling hysteresis and two damping peaks: one due to a stress induced relaxation mechanism operating near 200 K [1 Hz] and another one, at about 260-270 K, which could not be correlated with any step in the modulus, indicating that it is not anelastic in origin. The high temperature damping was described by an exponential background and a broad peak contribution centered at about 400 K (1 Hz). The resulting maximum is frequency dependent, but it is little sensitive to applied fields up to 30 mT. On contrary, the elastic modulus behavior associated to this maximum resulted largely affected by frequency, the external fields and the magnetic state of the sample.