The Effect of Punch Radius on the Deformation of Ultra-High Strength Steel in Bending

• Published in: Key engineering materials 2015-03, Vol.639, p.139-146
• Main Authors: Ruoppa, Raimo, Kesti, Vili, Arola, Anna Maija
• Format: Article
• Language: English
• Subjects: Bend tests; Bending; Deformation; Formability; Punches; Quality; Steels; Strength
• ISSN: 1013-9826; 1662-9795; 1662-9795
• DOI: 10.4028/www.scientific.net/KEM.639.139

Bendability is an important material property for ultra-high strength steel. The bendability of a certain material is expressed as the minimum bending radius Rmin of the inner surface of the bend and expressed in multiples of the sheet thickness. Bendability is limited by either cracking on the surface or the edges of the bend or by surface waviness that usually precedes cracking on the outer surface. Surface waviness is a form of strain localization in bending and the intensity of the phenomenon is dependent on e.g. the punch radius, the lower tool width and the sheet thickness. In this study the bendability of a 960MPa grade steel was investigated using optical strain measurements of three-point bending tests to determine the strain level and the bending angle when localization starts with different punch radii. The unbent samples were marked with a grid using laser marking and the deformation was measured with the GOM ARGUS strain analysis system after bending. The quality of the bend was also evaluated visually. In addition, tensile tests were performed and evaluated with the GOM ARAMIS deformation analysis system to investigate the local mechanical properties of the studied steel. The results of strain measurements and visual evaluation were then compared. It was found that beyond a certain angle the maximum strain across the bend did not significantly change with further increases in the bending angle when the punch radius was at least three times the sheet thickness. But with smaller punch radii the maximum strain increased almost linearly with increasing bending angle until fracture appeared. With the smaller punch radii deformation localizes and surface waviness begins to form in smaller bending angles because the deformation is concentrated in a narrow zone.