Evolution of Microstructure and Stress Corrosion Cracking Behavior of AA2219 Plate to Ring Weld Joints in 3.5 Wt Pct NaCl Solution

• Published in: Metallurgical and materials transactions. A, Physical metallurgy and materials science Physical metallurgy and materials science, 2016-04, Vol.47 (4), p.1607-1620
• Main Authors: Venugopal, A., Narayanan, P. Ramesh, Sharma, S. C.
• Format: Article
• Language: English
• Subjects: Aluminum alloys; Aluminum base alloys; Characterization and Evaluation of Materials; Chemistry and Materials Science; Corrosion resistance; Grain boundaries; Joint surgery; Materials Science; Mechanical properties; Metallic Materials; Microstructure; Nanotechnology; Physical metallurgy; Segregations; Stress corrosion cracking; Structural Materials; Surfaces and Interfaces; Thin Films; Welded joints; Welding
• ISSN: 1073-5623; 1543-1940
• DOI: 10.1007/s11661-016-3332-y

AA2219 aluminum alloy plate (T87) and ring (T851) were joined by tungsten inert gas (TIG) welding using multi-pass welding. The mechanical properties and stress corrosion cracking (SCC) resistance of the above base metals (BMs) in different directions (L, LT, and ST) were examined. Similarly, the weld metal joined by plate to plate and plate to ring (PR) joints was evaluated. The results revealed that the mechanical properties of the ring were comparatively lower than the plate. This was found to be due to the extremely coarse grain size of the ring along with severe Cu-rich segregation along the grain boundaries when compared to the plate material. The SCC resistance of the base and weldments were found to be good and not susceptible to SCC. This was shown to be due to high values of SCC index (>0.9) and the typical ductile cracking morphology of the BM and the weld joints after SCC test in the environment (3.5 wt pct NaCl) when compared to test performed in the control environment (air). However, the corrosion resistance of the weld interface between the FZ and ring was inferior to the FZ–plate interface.