Use of a direct mercury analyzer registered for mercury speciation in different matrices without sample preparation

• Published in: Analytical methods 2017-04, Vol.9 (14), p.2159-2167
• Main Authors: Windmoller, Claudia Carvalhinho, Silva, Nayara Carolinne, Morais Andrade, Pedro Henrique, Mendes, Louise Aparecida, Magalhaes do Valle, Claudia
• Format: Article
• Language: English
• Subjects: Analyzers; Heating; Mercury (metal); Quantitative analysis; Reference materials; Speciation; Transformations
• ISSN: 1759-9660; 1759-9679
• DOI: 10.1039/c6ay03041f

Use of thermal release to obtain mercury speciation information has long been used. In this work, operational conditions of a commercial thermal direct mercury analyzer (DMA-80 Milestone), which is normally used for total mercury determination, were investigated for performing mercury speciation. Mercury standards (Hg0, HgCl2, Hg2Cl2, HgSO4 and HgS) were prepared using solid dilution (concentrations up to 300 mu g kg-1). These samples and eight reference materials were analyzed. Fixed operating conditions of analysis included the following stepwise heating levels: 50, 100, 150, 200, 250, 300, 400, 500, 600 and 700 degree C. From the results, it was possible to observe differences in the mercury temperature release profile for the standard samples. The analysis of the reference materials showed appropriate agreement with certified mercury concentrations and with the sum of those obtained at each temperature level. The performance of this equipment for mercury speciation was compared with the use of another mercury thermal desorption equipment that employs continuous heating. The two main advantages of using the direct mercury analyzer were that it enabled quantitative analysis including detection of Hg0 in the mu g kg-1 concentration range and analysis of very small sample quantities, allowing a greater variety of studies on redox transformations of the metal in environmental matrices.