Improvement of electromechanical actuating performances of a silicone dielectric elastomer by dispersion of titanium dioxide powder

• Published in: IEEE transactions on dielectrics and electrical insulation 2005-08, Vol.12 (4), p.835-843
• Main Authors: Carpi, F., Rossi, D.D.
• Format: Article
• Language: English
• Subjects: Capacitive sensors; Ceramics; Dielectric constant; Dielectric materials; Dielectric measurements; Polymers; Powders; Stress; Studies; Titanium; Transmission line matrix methods
• ISSN: 1070-9878; 1558-4135
• DOI: 10.1109/TDEI.2005.1511110

This paper presents the first reported data on the embedding of highly dielectric ceramic inclusions in a rubbery host medium as a means to increase the electromechanical material response for dielectric elastomer actuation. The studied polymer/ceramic composite, consisting of a silicone matrix in which titanium dioxide powder was dispersed, exhibited, in comparison with pure silicone, a decreased elastic modulus, as well as an increased dielectric constant. The measured low frequency permittivity resulted in accordance with several classical dielectric mixing rules. The use of this material as elastomeric dielectric for planar actuators enabled a reduction of the driving electric fields, so that a transverse strain of 11% at 10 V//spl mu/m and a transverse stress of 16.5 kPa at 9 V//spl mu/m were obtained. These levels of strain and stress were respectively more than eight and four times higher than the corresponding values generated with the pure polymer matrix for analogous electrical stimuli.