Mechanical properties of Nafion and titania/Nafion composite membranes for polymer electrolyte membrane fuel cells

• Published in: Journal of polymer science. Part B, Polymer physics Polymer physics, 2006-08, Vol.44 (16), p.2327-2345
• Main Authors: Satterfield, M. Barclay, Majsztrik, Paul W., Ota, Hitoshi, Benziger, Jay B., Bocarsly, Andrew B.
• Format: Article
• Language: English
• Subjects: ionomer; mechanical properties; Nafion; PEM fuel cells; polymer composites; structure-property relations; water sorption
• ISSN: 0887-6266; 1099-0488
• DOI: 10.1002/polb.20857

Measurements of the mechanical and electrical properties of Nafion and Nafion/titania composite membranes in constrained environments are reported. The elastic and plastic deformation of Nafion‐based materials decreases with both the temperature and water content. Nafion/titania composites have slightly higher elastic moduli. Thecomposite membranes exhibit less strain hardening than Nafion. Composite membranes also show a reduction in the long‐time creep of ∼40% in comparison with Nafion. Water uptake is faster in Nafion membranes recast from solution in comparison with extruded Nafion. The addition of 3–20 wt % titania particles has minimal effect on the rate of water uptake. Water sorption by Nafion membranes generates a swelling pressure of ∼0.55 MPa in 125‐μm membranes. The resistivity of Nafion increases when the membrane is placed under a load. At 23 °C and 100% relative humidity, the resistivity of Nafion increases by ∼15% under an applied stress of 7.5 MPa. There is a substantial hysteresis in the membrane resistivity as a function of the applied stress depending on whether the pressure is increasing or decreasing. The results demonstrate how the dynamics of water uptake and loss from membranes are dependent on physical constraints, and these constraints can impact fuel cell performance. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2327–2345, 2006