VRLA automotive batteries for stop&go and dual battery systems

• Published in: Journal of power sources 2005-06, Vol.144 (2), p.411-417
• Main Authors: May, G.J., Calasanzio, D., Aliberti, R.
• Format: Article
• Language: English
• Subjects: Applied sciences; Battery; Battery monitoring; Direct energy conversion and energy accumulation; Electrical engineering. Electrical power engineering; Electrical power engineering; Electrochemical conversion: primary and secondary batteries, fuel cells; Exact sciences and technology; Lead-acid; State-of-charge; State-of-health; Valve-regulated
• ISSN: 0378-7753; 1873-2755
• DOI: 10.1016/j.jpowsour.2004.11.008

The electrical power requirements for vehicles are continuing to increase and evolve. A substantial amount of effort has been directed towards the development of 36/42 V systems as a route to higher power with reduced current levels but high implementation costs have resulted in the introduction of these systems becoming deferred. In the interim, however, alternator power outputs at 14 V are being increased substantially and at the same time the requirements for batteries are becoming more intensive. In particular, stop&go systems and wire-based vehicle systems are resulting in new demands. For stop&go, the engine is stopped each time the vehicle comes to rest and is restarted when the accelerator is pressed again. This results in an onerous duty cycle with many shallow discharge cycles. Flooded lead–acid batteries cannot meet this duty cycle and valve-regulated lead-acid (VRLA) batteries are needed to meet the demands that are applied. For wire-based systems, such as brake-by-wire or steer-by-wire, electrical power has become more critical and although the alternator and battery provide double redundancy, triple redundancy with a small reserve battery is specified. In this case, a small VRLA battery can be used and is optimised for standby service rather than for repeated discharges. The background to these applications is considered and test results under simulated operating conditions are discussed. Good performance can be obtained in batteries adapted for both applications. Battery management is also critical for both applications: in stop&go service, the state-of-charge (SOC) and state-of-health (SOH) need to be monitored to ensure that the vehicle can be restarted; for reserve or back-up batteries, the SOC and SOH are monitored to verify that the battery is always capable of carrying out the duty cycle if required. Practical methods of battery condition monitoring will be described.