A finite fracture mechanics approach to structures with sharp V-notches

• Published in: Engineering fracture mechanics 2008-05, Vol.75 (7), p.1736-1752
• Main Authors: Carpinteri, A., Cornetti, P., Pugno, N., Sapora, A., Taylor, D.
• Format: Article
• Language: English
• Subjects: Exact sciences and technology; Finite fracture mechanics; Fracture mechanics (crack, fatigue, damage...); Fracture toughness; Fundamental areas of phenomenology (including applications); Physics; Solid mechanics; Static elasticity (thermoelasticity...); Structural and continuum mechanics; Tensile strength; V-notches
• ISSN: 0013-7944; 1873-7315
• DOI: 10.1016/j.engfracmech.2007.04.010

Criteria assuming that failure of quasi-brittle materials is affected by the stresses acting over a finite distance from the crack tip are widely used inside the scientific community. For instance, they have been applied to predict the failure load of specimens containing sharp V-notches, assuming as a critical parameter the average stress ahead the notch tip. However, this kind of approaches disregards energy balance considerations, which, as well known, are the basis of linear elastic fracture mechanics (LEFM). In order to overcome these drawbacks, the present paper uses a recently introduced finite fracture mechanics (FFM) criterion, i.e. a fracture criterion assuming that crack grows by finite steps. The length of this finite extension is determined by a condition of consistency of both energy and stress requirements; as a consequence, the crack advancement is not a material constant but a structural parameter. The criterion is applied to structures with sharp V-notches. The expression of the generalized fracture toughness, which is a function of material tensile strength, fracture toughness and notch opening angle, is given analytically. Finally, we provide comparisons with: (i) the experimental data we obtained from testing Polystyrene specimens under three point bending; (ii) some experimental data available in the literature. The agreement between theoretical predictions and experimental results is generally satisfactory and, for most of the cases analyzed, the FFM predictions are better than the ones provided by the simple average stress approach.