A method for measuring joint kinematics designed for accurate registration of kinematic data to models constructed from CT data

• Published in: Journal of biomechanics 2001-03, Vol.34 (3), p.377-383
• Main Authors: Fischer, K.J., Manson, T.T., Pfaeffle, H.J., Tomaino, M.M., Woo, S.L.-Y.
• Format: Article
• Language: English
• Subjects: Arthrography; Biomechanical Phenomena; Computed tomography; Computer Simulation; Computer visualization; Forearm; Forearm motion; Geometrical registration; Humans; Imaging, Three-Dimensional; Joints - physiology; Kinematic measurements; Models, Biological; Rotation; Tomography, X-Ray Computed
• ISSN: 0021-9290; 1873-2380
• DOI: 10.1016/S0021-9290(00)00195-0

A method for measuring three-dimensional kinematics that incorporates the direct cross-registration of experimental kinematics with anatomic geometry from Computed Tomography (CT) data has been developed. Plexiglas registration blocks were attached to the bones of interest and the specimen was CT scanned. Computer models of the bone surface were developed from the CT image data. Determination of discrete kinematics was accomplished by digitizing three pre-selected contiguous surfaces of each registration block using a three-dimensional point digitization system. Cross-registration of bone surface models from the CT data was accomplished by identifying the registration block surfaces within the CT images. Kinematics measured during a biomechanical experiment were applied to the computer models of the bone surface. The overall accuracy of the method was shown to be at or below the accuracy of the digitization system used. For this experimental application, the accuracy was better than ±0.1 mm for position and 0.1° for orientation for linkage digitization and better than ±0.2 mm and ±0.2° for CT digitization. Surface models of the radius and ulna were constructed from CT data, as an example application. Kinematics of the bones were measured for simulated forearm rotation. Screw-displacement axis analysis showed 0.1 mm (proximal) translation of the radius (with respect to the ulna) from supination to neutral (85.2° rotation) and 1.4 mm (proximal) translation from neutral to pronation (65.3° rotation). The motion of the radius with respect to the ulna was displayed using the surface models. This methodology is a useful tool for the measurement and application of rigid-body kinematics to computer models.