Hot ductility of a Fe–Ni–Co alloy in cast and wrought conditions

• Published in: Materials in engineering 2011-05, Vol.32 (5), p.2956-2962
• Main Authors: Yazdani, M., Abbasi, S.M., Momeni, A., Karimi Taheri, A.
• Format: Article
• Language: English
• Subjects: Cast alloys; Ductility; Elongation; Ferrous alloys; Iron; Tensile tests; Wrought alloys; Yield strength
• ISSN: 0261-3069
• DOI: 10.1016/j.matdes.2011.01.051

► The Fe–29Ni–17Co is a low expansion alloy used as glass-to-metal sealing purpose. ► The hot ductility of Fe–29Ni–17Co was determined via hot tensile test. ► The best hot ductility caused by DRX was found at 1150–1250 °C. The hot ductility of Fe–29Ni–17Co alloy was studied in both cast and wrought conditions by hot tensile tests over temperature range of 900–1250 °C and at strain rates of 0.001–1 s −1. Over the studied temperature range, the wrought alloy represented higher elongation and reduction in area as compared to the cast alloy. Dynamic recrystallization was found responsible for the higher hot ductility of the wrought alloy and the improvement of hot ductility of the cast alloy at high temperatures. At temperature range of 1000–1150 °C the wrought alloy exhibited a hot ductility drop while a similar trough was not observed in case of the cast alloy. It was also found that at temperatures of 1150–1250 °C the best hot ductility is achieved in both cases of cast and wrought alloy. The experimental data of flow stress were constitutively analyzed and the apparent activation energy of deformation was estimated to be 344 kJ/mol.