Influence of process and formulation parameters on the formation of submicron particles by solvent displacement and emulsification―diffusion methods Critical comparison

• Published in: Advances in colloid and interface science 2011-04, Vol.163 (2), p.90-122
• Main Authors: MORA-HUERTAS, C. E, FESSI, H, ELAISSARI, A
• Format: Article
• Language: English
• Subjects: Biodegradability; Chemistry; Colloidal state and disperse state; Criteria; Design engineering; Displacement; Exact sciences and technology; Formulations; General and physical chemistry; Physical and chemical studies. Granulometry. Electrokinetic phenomena; Polymers; Raw materials; Solvents
• ISSN: 0001-8686; 1873-3727
• DOI: 10.1016/j.cis.2011.02.005

Solvent displacement and emulsification-diffusion are the methods used most often for preparing biodegradable submicron particles. The major difference between them is the procedure, which results from the total or partial water miscibility of the organic solvents used. This review is devoted to a critical and a comparative analysis based on the mechanistic aspects of particle formation and reported data on the influence of operating conditions, polymers, stabilizing agents and solvents on the size and zeta-potential of particles. In addition, a systematic study was carried out experimentally in order to obtain experimental data not previously reported and compare the data pertaining to the different methods. Thus the discussion of the behaviors reported in the light of the results obtained from the literature takes into account a wide range of theoretical and practical information. This leads to discussion on the formation mechanism of the particles and provides criteria for selecting the adequate method and raw materials for satisfying specific objectives in submicron particle design.